Meco 2400 Bedienungsanleitung

FOR YOUR SAFETYIf you smell gas:1. Do not attempt to light appliance. 2. Extinguish any open flame.3. Disconnect from fuel supply.FOR YOUR SAFETY1. Do

10· If the hose and regulator assembly is not working properly and you need a replacement, contact the manufacturer(1-800-251-7558). Be sure to specif

11FIG. 10BFIG. 10EFIG. 10CFIG. 10D· To avoid gas in your face and eyes, do not hold an LP cylinder connection toward you when disconnecting. STEP3) Co

12How to perform a leak test:Supplies Needed for a Leak Test: Clean paintbrush, water, and dish washing liquid.1) Use a 1 pound disposable LP Cylinder

1. Open the Hood. Make sure LP cylinders are installed.2. Important: Make sure main grill control knob is turned “Off” first. 3. Push the control knob

IGNITION LIGHTING THE SIDE BURNER 1. Remove Side Burner Cover if on.2. Important: Make sure Side Burner Control Knob is turned “Off” first. 3. Turn Si

IGNITION LIGHTING THE LANTERN 1. Check to make sure lantern parts are intact and not disrupted and cylinder is properly connected. 2. Important: Make

16OPERATING THE LP GAS GRILLTo reduce the risk of serious bodily injury or death:· Never use charcoal in your LP gas grill. Do not use aerosols or sto

1) When you have finished using your grill, turn the grillControl Knob clockwise to the “Off” position. Make sure there are no open flames nearby,2) D

FIG. 18EFIG. 18FSide BurnerInlet HoleClear Clogged PortHoles with small nailor WireFIG. 18DMainBurnerInlet HoleClear Clogged Port Holeswith small nail

19FIG. 19BStore Side Tableor Side Burneron Cooking GridCollar is towardthe front Tuck hoseloop intoflangeFIG. 19AFIG. 19CMain Grill Regulator must bet

I. Assembly Instructions...2A) Parts Illustrations...

20LP gas cylinder is emptyReplace 1 pound disposable cylinder.Make sure gas Collector, Ignitor and electrodes are tight. Make sureelectrode wires and

21Persistent greasefireGrease trapped aroundburner systemTurn control knob “Off”. Open hood carefully and let fire burn out.After the grill cools, rem

MECO CORPORATIONLIMITED WARRANTYThis product is warranted to the original consumer purchaser against defects in material and workman-ship under normal

23

24P/N 03.6506.00REV. 04/06 Aussie AdventurerTM

To reduce the risk of a cut or pinching injury:· Wear protective gloves when handling parts that have sharp edges.· When opening legs, keep hands and

Instructions for Locking/UnLocking LegsNote: Use these steps after Step 2 of Owner’s Manual. After setting the grill up on all three legs, grab therod

3Parts Replacement Illustrations122610973536238143561215133819202527283134404142293730332411432391621172218

PARTS LISTITEM DESCRIPTION PART #1 Owner's Manual 03.6506.00 1 1 1 1 12 Hood w/Hinges 03.6506.01 1 1 1 1 13 Screw, M6x9 Shoulder (Hood Hinge) 03

PARTS LIST (CONT'D)ITEM DESCRIPTION PART #29 Heat Shield 03.6506.27 1 1 1 1 130 Screw, ST3.8x6mm (Heat Shield) 03.6506.28 2 2 2 2 231 Guide Brack

6FIG. 2BSTEP 2) Lift grill up at one leg mount. Release thespring lever at each leg foot. (FIG. 2A) Swing eachleg all the way out one at a time, and l

Insert the tubular collar into the left leg PTOTM(Propane Take-OffTM) opening of the grill until theSide Table rests snugly against the grill body. (F

STEP 3) Hook SideBurner Grid into farleft hole in side tableand lower two wiresinto the other twoholes. (FIG. 5E)FIG. 5ESTEP 4) Your Side Burner can b

STEP 5) Portable Use of Lantern:Lantern can be connected to a 1 lb.cylinder for use as a portable light.(FIG. 7G) Hold the Lantern withone hand. Inser